Improvement of Pulse Shape by Reducing Ripple Using Coaxial Cable Manuscript Received: 14 February 2023, Accepted: 28 March 2023, Published: 15 September 2023, ORCiD: 0009-0002-6869-8209,

Main Article Content

Yin Yin Mya


Even though pulse shape in rectangular form is desirable for most applications, pulse generated from coaxial cable has ripple and is not in desired rectangular shape. This study is to improve the pulse shape generated from coaxial cable to be rectangular shape. Coaxial cables with difference dielectric materials are studied for generation 100 ns pulse. The study has been carried out by state space representation method and MATLAB simulation for pulse forming network of Type-B which has same characteristics of coaxial cable. Ripple can be reduced to 2% to 3% increasing the inductance values next load higher than characteristics inductance of coaxial cable.

Article Details

Author Biography

Yin Yin Mya, Department of Electrical Power Engineering, West Yangon Technological University, Myanmar

Advance of Science and Technology, Ministry of Science and Technology, Yangon, Myanmar


M. Q. Taha, Y. I. Al-Mashhadany and A. Lpizra, “High Performance of the Coaxial Cable Based on Different Dielectrics,” J. Telecom., vol. 28(2), pp. 1-6, 2014.

L. Qian and Z. Shan, “Coaxial Cable Modeling and Verification”, BSc Thesis, Blekinge Institute of Technology, Sweden, 2012.

H. J. Ryoo and J. S. Kim, “Development of Rectangle- Pulse Marx Generator Based on PFN,” IEEE Trans. Plasma Sci., vol. 37(1), pp. 190 – 194, 2009.

A. K. A. Selman, “Using of The Coaxial Cable to Construct a Current Pulse Generator,” Journal of Kerbala University, vol.5, no.2 Scientific, pp. 38-47, 2007.

H. Kijima and K. Ochi, “High Voltage Pulse Generator by Connection Normal Coaxial Cables in Series and in Parallel without Using Blumlein Method,” WSEAS Trans. Circuits and Sys., vol. 12(12), pp. 366-375, 2013.

H. Ghawde and R. Harchandana, “Pulse Forming Network with Optimized Pulse Power and Rise Time,” in Int. Conf. Advances in Comput., Comm. and Control, India, pp. 1-4, 2017.

P. J. Rathod, V. P. Anitha Z. H. Sholapurwala and Y. C. Saxena, “A Guillemin Type E Pulse Forming Network as the Driver for a Pulse, High Density Plasma Source,” Rev. Scientif. Inst.,vol. 85, 063503, 2014.

R. Kour and R. S. Chib, “Effect of Different Component Values on 3-Stages Type-B Pulse Forming Network,” Int. J. Eng. and Comput. Sci., vol. 3(1), 2014.

F. Li, F. Song, M. D. Zhu and H. T. Gong, “A Compact High-Voltage Pulse Forming Module with Hundreds of Nanoseconds Quasi-Squared Output Pulse,” Rev. Scientif. Inst., vol. 89, 104706, 2018.

R. C. Dorf and R. H. Bishop, Modern Control System, 11th ed, Person Education Inc, 2018.